Double Charge Station for Wii

【ELECTRICAL PARAMETERS】
1. No-load Voltage : DC2.0-2.85V
2. Maximum Output Current : DC 450mA
3. Input Voltage:DC 5.0V
4. Empty Display : No Light
5. Charging Display : Red
6. Full Power Display : Bright Blue Light
7. Charging Duration : About 7 hours ( If the rechargeable battery pack is removed half-way , then the charging duration need to be recounted again )
8. Blue Light Base : Blue light is on during charging, it is off when the battery pack is taken away
BATTERY PACK PARAMETERS
1.Battery pack capacity : 2800mAH
2.Battery Type : Ni-MH battery
3.Voltage : DC2.4-2.8V
4.Duration : More than 7 hours of continuous use . (Note : There are different currents pass thought the controller in different games . Therefore , the duration of battery pack may vary. )

【product specification 】
weight：301g
size：25*15*8cm

【Package includes】
2800mAH battery*2
charge Station *1

【USER MANUAL】
1.DC5V power supply will be inserted into the correct DC input jack . and the power switch is turned "ON"
2.Put the equipped 2pcs rechargeable batteries into controllers , and then insert the controllers into the charger to start charging . LED will be red during charging . After 7 hours , The LED will turn blue when the charging is complected .
Can connect to the Motion Plus
Empty Display : No Light
Charging Display : Red
Full Power Display : Bright Blue Light
Compatible with or without Motion Plus

【ATTENTION】
1.Please note that the correct voltage input is not higher than 5.6V . This prevents the product from overheating.
2.The charging duration is 7 hours and the power should not be stopped . If the power stops , the charging duration should be recounted again .
3.The largest time error of LED light switching between the 2pcs battery pack is 33.6 minutes .
4.Don`t put the product into the water or flame . Keep it in a dry and safe place .
5.Please use the product properly .

The nintendo wii controllers Nunchuk is the first system shows the Nintendo Wii Remote for the Tokyo Game Show 2005. It connects to the controller nintendo wii via a line or above 3.5 to 4 feet (1 to 1.2 meters) long. It looks the same as the connection Nunchaku, hence the name. Nintendo wii controllers has an analog stick, similar to the (change in the last minute to change a trigger, two triggers and a "C" key, as described below) in the GameCube game controller and found two trigger buttons. Controller nintendo wii works with the master controller and synchronization in many games. Nintendo wii controllers as the Nunchuk also offers a three-axis accelerometer and tilt sensor movement, but not a speaker, rumble feature or a function pointer. The acceleration of the controller nintendo wii Nunchuk is LIS3L02AL STMicroelectronics. 

A bundled with the Wii Nunchuk. Additional nintendo wii controllers Nunchuk unit is not sold separately. Two shoulder buttons, formerly known as Z1 and Z2 have been modified and renamed as the Game Developers Conference. Shoulder top radio button, now C is much smaller than the low rectangular shoulder button, now z The Agency controller nintendo wii Nunchuk measures 113 mm (4.45 inches) long, 38 mm (1.5 inches) wide and 37 mm (1.48 inches) thick. 

Nintendo wii controllers Nunchuk board ,The nintendo wii controllers Nunchuk can be connected to any microcontroller via I ² C (as Atmel AVR), where the acceleration, joystick and buttons, the data can be accessed. Todbot created Wiichuck, adapter for easy connection Nunchuk board. In the year 2008 began with Wireless Nunchuk by one or more third-party, whereby the line and connects the nintendo wii controllers Remote and Nunchuk.